Lamborghini Talk banner
1 - 1 of 1 Posts

·
Registered
Maserati 3500 GTi 1962
Joined
·
1 Posts
Discussion Starter · #1 ·
The distributor is in very nice condition and spins very good.
It has no points or condensors which are renewed anyway normally.
The only other thing missing are the 2 plates that hold the points. If you plan to use an electronic Hall sensor, these plates should be adapted anyway (see other discussion about electronic ignition for Urraco on this forum). I've seen them for sale at Hill Engineering.
The distributor is complete with the unique drive gear for Urraco on the lower side.

I'm a Maserati man but sometimes some Lamborghini parts come to me, as this distributor.

I did my homework and found out that this specific type S127E is for the Lamborghini Urraco. I've seen other discussions, where people mention that the Ferrari 308/328 distributor (type S127G) is the same, but this is only partly true. Same for the Alfa Montreal distributor (types S127C and S127D).
The Urraco distributor has a longer shaft and housing on the rear and there is also the gear to drive the distributor, which are specific Lambo parts I believe.

What is the same with Ferrari and Alfa I think are the rotor, cap, points and condensor (which is nice if you need to find parts).

I would like 1000 Euro for the distributor as pictured.

Please note: I also have some gearbox parts for 350GT, 400 GT, Islera, Espada, Jarama, Miura, which I will show in another discussion or check my homepage.

Thanks for looking.

289427


289428


289429


289430


289431


289432


289433


289434
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top