Lamborghini Talk banner
1 - 1 of 1 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter · #1 ·
Hello,

Has anyone else encountered problems with new lower ball joints for the Countach from Lamborghini? (Part #005109520). Our car is a 1979 LP400S model.

The dimensions of the pair Lamborghini sent us are quite different than the original set in many ways. The press surface DIA is too large. Also the joint they sent us also has a different taper and the taper is located in a different position on the shaft. I have reached out to a few parts sources and sent photos and they stock the same part Lamborghini sent us.

The original joints have GM stamped into the bottom of them. Does anyone know what model these may have come off of? We are thinking some sort of Opel, Vauxhall, etc.

Any help would be greatly appreciated.

Thanks!
 

Attachments

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top