Has someone pictures of the original door stop? Now i have three different door stops and i dont know how they fit to my door? Maybe a picture from the door stop in the car would help me.....

Hello, I think these are the originals,
I am not 100% sure because I am rebuilding my car and it is in pieces now.
GRS Paul

Attached Images

Deurbegrenzing_800x600.jpg (57.3 KB, 13 views)

__________________
Urraco 15184

Hello Paul, yes these Parts looks like mine too, but there is a rubber Part and two other parts missing, and i have some parts but dont know how the match togeter.... i will send this evenig more pictures.....

My Urraco door stoppers are broken as well. Very interested to find out what parts I need to fix them.

Here are references to discussions for the Jalpa door stoppers, which I suspect may be the same parts for the Urraco:
Jalpa Tech Article - How to Repair/Rebuild Door Travel Limiter (Door Stops / Checks)
looking for the door stop's

Laust

__________________
Jalpa TT #ELA12161
Espada #8356

Here you can see the original aluminium housings from the door stop, and three different rubber door stops, the shorter ones are only slightly different, and the longer one, see by yourself.
i dont know in witch position the rubber slides between the housing, the rubber parts are the same for left and right, one side mount upside down to the other side....

Attached Images

	BILD1352.jpg (45.3 KB, 18 views)
	BILD1353.jpg (39.7 KB, 19 views)
	BILD1354.jpg (55.2 KB, 20 views)
	BILD1355.jpg (35.8 KB, 19 views)
	BILD1356.jpg (41.5 KB, 22 views)

I found this picture I made from another car, hope it helps a little!
GRS Paul

Attached Images

P1020402_800x600.jpg (69.8 KB, 25 views)

__________________
Urraco 15184

Hello Paul, thank you, but it is to small and i need a picture from inside the door think.....
the problem is, there was nothing from the door stop in my car..... :-(

Judging by this thread it would seem to be a very common problem, no doubt time and use has taken its toll on the door strap.
I have the exact same issue with my P300 so any advice of how to repair and/or replace is much appreciated.

Today i finished the horror with the door stops, i used the parts i bought. They where for a alfa, i used the old aluminum housings, not the new one i also bought, this one was to small.
I have two different lenght of door stop straps, i used the shorter one, you could see in them pictures above. I had to make 4 plastic parts ( 2 for each side, the door strap slides between them, they are mounted on the aluminium housing) by myself that also needed, but no problem when you have a lathe.
Now the door stops correct and have the position between closed and fully opend as well.