Hello.

Purchased a stebro racing exhaust from Stebro, there were 2 different ones, i chose the exhaust with just resonators. Will this make the Jalpa obnoxiously loud? Also there is a little rust hole at the very bottom of the header where it comes straight down from the engine then angles up 45 degrees. It llooks like water settling there caused this,(do not drive it as much as i should) it is very annoying because it makes a loud popping when idling or downshifting. Tried to thread a self tapping bolt in there but it did not work. Kind of hard to get to with a welder, any ideas? P.s. will removing the air pump belt cause any issues.

Thank you for your time, and appreciate your input.

Eric.

Hi Eric,

the popping is from the engine/carb setting.
You can remove the airpump belt without problem this will help against the popping too.

__________________
RaymondQV
Countach QV Ex-Mimran #GLA12997, Urraco P300 #20530, Jalpa #FLA12203 sold in May 2006
www.countach.ch
www.jalpa.ch

When Frank Sinatra got his Miura S in 1970, he said: “If you wanna be someone, buy Ferrari - If you are someone, you own a Lamborghini”.

Are there any cross reference exhaust mating gaskets that is\
should be trying to obtain before my stebro system gets here? Or where i could obtain new ones?

I am also unsure if my car has ever been registered? Have had it over 2 years now and not sure if i ever did.? la12329

Eric.

I believe you can purchase the gaskets directly from Stebro.

How'd it sound?

__________________
Jalpa #ELA12131