People, I was wondering if someone could help me out with the following torque settings and clearances? The workshop has asked for clarification on these settings as it is not clear in the Urraco 3000 engine workshop manual and they want clarification that the 3500 engine of the Jalpa uses the same torque settings. It would be handy if I could get the foot pound or NM torque settings. I am chasing the following
1. Main (crankshaft) bearing cap nuts
2. Big end bearing nuts
3. Head bolts

I am also chasing the clearance for the crank shaft main bearings ie once the main bearings have been fitted and torqued down what is the clearance that should be measured?

TIA

Mike

__________________
Jalpa ELA12175