Originally Posted by suzukidave

as you look at the sensors from the rear of the car, looking forward the top one controls bank 7 to 12 and the bottom one controls bank 1 to 6.
The yellow plug contols banks 7 to 12, the white 1 to 6. So hook up the top sensor to the yellow plug, the bottom one to the white.
to set the sensors in time, jack the car up and put the flywheel 30 degrees before tdc. There is a dimple drilled in the flywheel 30 degrees before tdc. when this is lined up. You can see this through a hole in the bell housing under the car. Once this is lined up the pointer on the phase sensor should be lined up with the lower (1-6) sensor. Continue on to tdc on the flywheel and the pointer should be directly between the two pickups on the phase sensor. I checked my old notes and found that when I purchased my car they had them reversed and had the pointer at the lower one at tdc. completely screwed up, but the car ran.

dave