Continued
I have included a picture of the tools I used to remove the spoiler just for your refernce. 10mm & 13mm socket, 1/4 inch racket set, 6 inch extension bar, pliers, telescopic magnetic pickup tool and torch I have included the picture.
Remove the rubber grommets as indicated in picture4.
Then use the 13mm socket, 6 inch extension bar and ratchet to remove the nuts securing the spoiler to the fender as indicated in picture 5 it is on quiet an angle.
As you can see from picture 6 the washer will NOT fit through the holes, use the magnetic pickup tool to remove the washers, angle them towards the vents and then use long nose pliers to grab them as indicated in picture 7.
NOTE 1/2 inch socket set sockets will NOT fit through the grommet holes.
__________________
Jalpa ELA12175
Last edited by Jalpa_Aus : 12-28-2007 at 04:56 AM.
Reason: added tool magnetic pickup
|